煤矸石复合吸附剂对Zn~(2+)的吸附性能

采用某洗煤厂的煤矸石和天然粘土石灰石作为主要原料,添加适量的氯化铝制备吸附剂对Zn~(2+)进行吸附,运用SEM技术对吸附剂进行了表征,研究了不同因素对Zn~(2+)去除率的影响,并探讨了吸附机理。实验结果表明:当反应温度为20℃、振荡时间为70 min、废水pH为6、吸附剂投加量为0.5 g时,Zn~(2+)去除率达到96.28%。煤矸石复合吸附剂对Zn~(2+)的吸附符合准二级动力学方程,在高浓度时符合Langmuir等温吸附模型低浓度时符合Freundlich等温吸附模型,且吸附是易发生的。     

分散固相萃取/高效液相色谱法测定土霉素菌渣中土霉素的残留量

文章拟建立一种从土霉素菌渣中提取并检测土霉素残留量的高效液相色谱法。用甲醇和冰乙酸作为提取剂提取样品,用分散固相萃取的方法净化样品,净化药剂为石墨化碳黑(GCB)和C18。通过加标回收实验,用高效液相色谱仪检测样品中土霉素含量。选用的色谱柱为PLRP-S,流动相为甲醇和0.05 mol/L草酸,两者比例为35:65(V:V)。检测波长为355 nm,柱温30℃。经检测,土霉素在0.1~2 000 mg/L范围内线性相关系数大于0.999,线性良好。1.0,4.0及8.0mg/g 3个加标水平的土霉素平均回收率范围是80.85%~109.59%,相对标准偏差(RSD)为2.45%~6.38%。土霉素菌渣中土霉素残留量平均为4.741 mg/g。实验表明,该方法具有简单、方便、快速、准确性强、灵敏度高的特点,可以应用于土霉素的分析检测。     

A case study of microwave processing of metal hydroxide sediment sludge from printed circuit board manufacturing wash water

The large quantity of wash water used in the electroplating and etching process in the manufacturing of printed circuit boards (PCBs) contains a high level of heavy metal ions (Cu⁺⁺, Zn⁺⁺, Ni⁺⁺, Cr⁺⁺⁺, Pb⁺⁺). These potentially toxic ions are removed from the wash water effluent through a polyelectrolyte flocculation and hydroxide precipitation process during which a hydroxide sediment sludge rich in metal ions and polymers is generated. This sediment sludge possesses some unique characteristics and properties in terms of composition, fine particle size distribution, high specific surface area, and a tendency to agglomerate after drying. Direct disposal of this classified “special waste” (Department of Environment of Northern Ireland, The Special Waste Regulations, Northern Ireland, 1998) at landfill sites may cause serious soil and underground water pollution through a gradual ionic leaching process. This paper describes an experimental investigation, exploratory in nature, which employs microwave radiation for detoxification of the sediment sludge through microwave heating, drying and metal ion immobilization within the sediment solids. The effectiveness of microwave assisted binding and immobilization of the metal ions within the sediment solids was studied in conjunction with an evaluation of microwave energy efficiency in comparison to the more conventional convective heating and drying processes. Given a sufficient amount of microwave radiation, leaching of Cu²⁺ and Pb²⁺ was reduced by 2700% and 1080%, respectively, over a period of 12 weeks, and further leaching was not detectable within six months at simulated local landfill aqueous conditions. This paper also attempts, through experimental observation, to add to the very limited understanding of the complex interactions and binding of free metal ions with the polymeric materials and metal hydroxides under the influence of an electromagnetic field. The high specific surface of the sediment solids and their adsorption properties were further explored and characterized in a study of adsorption of reactive dyes by the microwave processed solids.     

污水中磷酸盐的离子交换分离初探

在日化工业磷酸盐解析方法的基础上，针对污水中各磷酸盐含量特征，对树脂床高度、淋洗液流速和用量等因素作了选择研究，确定了分离污水中各种磷酸盐及测定其含量的条件和步骤。     

氧化钙燃烧固硫添加剂的研究

在寻找钙基燃烧固硫加剂，并探讨其机理的试验中，研究了碱金属化合物在不同含量，不同温度下对氧化钙固硫率的影响，试验结果表明，一些碱金属化合物能使固硫率增加约１０个百分点左右，采用ＳＥＭ和热天平分析了固硫率提高的原因，提出碱金属化合物提高固硫率的机理在于：低熔点液相共熔物的形成导致ＣａＯ微观结构的改变。     

Removal of metal ions from the complexed solutions in fixed bed using a strong-acid ion exchange resin

Fixed bed removal of equimolar metal ions (Co²⁺, Ni²⁺, Mn²⁺, Sr²⁺) from aqueous solutions using a strong-acid resin was examined. The solution contained a water-soluble complexing agent including ethylenediaminetetraacetic acid, nitrilotriacetic acid, and citric acid. Experiments were performed under different solution pH and molar concentration ratios of complexing agent to the total metals. It was shown from batch studies that the equilibrium exchange of metals and the resin mainly depended on solution pH, and partly on the type of complexing agent used. A mass transfer model was proposed to describe the breakthrough curves of the resin bed, which contained two parameters (τ and k) estimated from the observed breakthrough data. The calculated breakthrough curves agreed well with the measured ones (standard deviation <6%). In fixed bed tests at low pH (=2), the type of complexing agent had little effect on the breakthrough data. For a given complexing agent, the metal with a larger overall formation constant (K_f) showed a smaller exchange capacity. For a given metal ion, the complexing agent with a larger K_f also revealed a smaller exchange capacity.     

Radionuclide and chemical concentrations in mineral waters at Saratoga Springs, New York

A project to characterize the radionuclide and chemical components in natural spring waters in the vicinity of Saratoga Springs, New York (USA) has been completed. As a result of the measured radionuclide and chemical content, eight springs were labeled as mineral waters, whereas three springs contained very low concentrations of these components. The mineral waters were highly enriched in alkaline and alkaline-earth elements, as well as chloride ions. Three isotopes of radium ((224)Ra, (226)Ra, (228)Ra) were detected in the mineral waters and reached concentrations of 1, 20, and 2 Bq/L, respectively. Overall, the (226)Ra isotope constituted about 80% of the total radioactivity measured in the water samples. Dissolved uranium concentrations in the mineral waters were very low (mean approximately 50 mBq/L).     

Analysis of accumulation, extractability, and metabolization of five different phenylarsenic compounds in plants by ion chromatography with mass spectrometric detection and by atomic emission spectroscopy

Phenylated arsenic compounds occur as highly toxic contaminants in former military areas where they were formed as degradation products of chemical warfare agents. Some phenylarsenic compounds such as roxarsone and aminophenylarsonic acids were applied as food additive and veterinary drugs in stock-breeding and therefore pose an environmental risk in agricultural used sites. Very few data exist in the literature concerning uptake and effects of phenylarsenic compounds in plants growing on contaminated soils. In this study, the accumulation, extractability, and metabolization of five different phenylarsenic compounds, phenylarsonic acid, p- and o-aminophenylarsonic acid, phenylarsine oxide, and 3-nitro-4-hydroxyphenylarsonic acid called roxarsone, by the terrestrial plant Tropaeolum majus were investigated. Ion chromatography coupled to inductively coupled plasma mass spectrometry was used to differentiate these arsenic compounds, and inductively coupled plasma atomic emission spectroscopy was used for total arsenic quantification. All compounds considered were taken up by the roots and transferred to stalks, leaves, and flowers. The strongest accumulation was observed for unsubstituted phenylarsonic acid followed by its trivalent analogue phenylarsine oxide that was mostly oxidized in soil whereas the amino- or nitro- and hydroxy-substituted phenylarsonic acids were accumulated to a smaller degree.The highest extraction yield of 90% for ground leaf material was achieved by 0.1 M phosphate buffer, pH 7.7, in a two-step extraction with a total extraction time of 24 h. The extraction of higher amounts of arsenic (50–70% of total arsenic present in leaves depending on arsenic species application) from non-ground intact leaves with deionized water in comparison with the buffer (20–40% of total arsenic) is ascribed to osmotic effects. The arsenic species analysis revealed a cleavage of the amino groups from the phenyl ring for plants treated with aminophenylarsonic acids. A further important metabolic effect consisted in the production of inorganic arsenate and arsenite from the phenylated arsonic acid groups.     

污泥加药调质中的有关问题探讨

污泥的加药调质条件对脱水性能的影响很大，在加药调质中，根据污泥性质，正确选择凝聚剂和絮凝的种类、规格和投加量是很关键的。在具体的调质工艺过程中，还有一些值得注意的环节。污泥脱水效果不佳，并不一定是脱水机的性能、污泥性或调质药剂等原因所至，有可能是在具体的调质工艺操作中的一些易忽视的环节出了问题，而这些对污泥调质效果往往是至关重要的。     

铝型材碱洗废液再生工艺研究

铝型材表面处理工艺中产生大量碱洗废液，如不能有效回收，会造成严重环境污染与资源浪费。本文针对含有“长寿碱蚀剂”的废液提出了生石灰处理工艺，此工艺简单，效果好，完全可以实现工业化生产。同时，该法原料价格低廉易得，实现闭路循环，可以达到良好的社会效益与经济效益。